can this edge pull be used with the omnia 7506 on the same door?
A. The only potential problem with using the Deltana EP6125 Edge Pull on a door where the Omnia 7506 Flush Pull is also installed would be if you had the flush pull so close to the edge that the cup of the flush pull interfered with the placement if the edge pull. Given the edge pull is only about 3/16" deep, though, the flush pull would pretty much have to be at the extreme end of the door, and even then you could get around it by installing the edge pull above or below where the flush pull is installed.
56% of 9 people found this useful. Was this useful?
yes
(
5) |
no
(
4)
What is the finish shown here and do you have the following in the same finish : Omnia 653.OM 4" L x 1-3/4" W Contemporary Flush Pocket Door Pull with 1/2" Cup Depth?
A. The Deltana EP6125 image is of that product in the Oil Rubbed Bronze finish. The Omnia 653.OM is not available in that finish.
86% of 7 people found this useful. Was this useful?
yes
(
6) |
no
(
1)
What is the depth into the door for installation?
A. The Deltana EP6125 is depth 0.18.
70% of 10 people found this useful. Was this useful?
yes
(
7) |
no
(
3)
